Metal paints like Hammerite and Polisan
Posted: Mon 04 Aug 2014 10:37 am
We just had railings put on our outside stairs and part of the roof. We expected it to be painted with a paint like Hammerite or Polisan. Some of the railings came pre painted, but as it turned out that the man we asked to do it, did not do it himself, but employed another man, the whole thing is turning into a nightmare.
First all the rails were not properly upright. When we complained he said 'no problem' (as they do) and cut them all and corrected them. We had to go out the next day and when we came back found that some of the units were not the right lenght and he had added bits and it looked terrible. My husband then had to get him to change that so it looked ok. They also had a couple of very young lads paint everything, half of it done when we came back. And thats the biggest problem. They put the paint (thinned down, so it looked like water) on without cleaning all the welders dust and other dirt off, also no primer or undercoat. The paint they used is FENOSEN synthetic paint. I checked it and it is just ordinary indoor/outdoor paint suitable for wood and metal.
So what do we do now?? Also keeping in mind that we live in Dipkarpaz, no fancy equipment here.
As we only gave them less than half the money, we feel we still have the upper hand.
We can make them correct it, but we want to be sure it is done right. I have used Polisan and I think its like Hammerite and very good. But can it be put on ordinary paint?? Especially as its only just been done??
Any thoughts would be appreciated
First all the rails were not properly upright. When we complained he said 'no problem' (as they do) and cut them all and corrected them. We had to go out the next day and when we came back found that some of the units were not the right lenght and he had added bits and it looked terrible. My husband then had to get him to change that so it looked ok. They also had a couple of very young lads paint everything, half of it done when we came back. And thats the biggest problem. They put the paint (thinned down, so it looked like water) on without cleaning all the welders dust and other dirt off, also no primer or undercoat. The paint they used is FENOSEN synthetic paint. I checked it and it is just ordinary indoor/outdoor paint suitable for wood and metal.
So what do we do now?? Also keeping in mind that we live in Dipkarpaz, no fancy equipment here.
As we only gave them less than half the money, we feel we still have the upper hand.
We can make them correct it, but we want to be sure it is done right. I have used Polisan and I think its like Hammerite and very good. But can it be put on ordinary paint?? Especially as its only just been done??
Any thoughts would be appreciated