Page 1 of 1

Fusible webbing or iron on interfacing

Posted: Sat 16 Aug 2014 2:07 pm
by StrictlyTP
Where can I purchase fusible backing or iron on interfacing does anyone know. I need it for appliqué cushions I'm making

I would prefer not go to Lefkosia in this heat but. If anybody knows anywhere North or South?

Re: Fusible webbing or iron on interfacing

Posted: Sat 16 Aug 2014 3:35 pm
by JBA
I bought some iron-on in the Pound Shop in Alsancak about 2 weeks ago but there was only a couple left after I took mine. I haven't tried it yet so I don't know if it is any good.

Re: Fusible webbing or iron on interfacing

Posted: Sat 16 Aug 2014 3:40 pm
by Lovelife
I bought some interfacing from the shop that is down the small alley behind the Brabantia shop.

LL

Re: Fusible webbing or iron on interfacing

Posted: Sat 16 Aug 2014 6:55 pm
by StrictlyTP
Thanks both

LL do you mean in Kyrenia? I live in Iskele
So am not too familiar with Girne - if so is it in the centre?

Re: Fusible webbing or iron on interfacing

Posted: Sun 17 Aug 2014 6:51 am
by cjtill
I have bought fusible webbing from the shop down the alley in Girne but it didn't stick very well as I think the 'glue' had dried out a bit in the heat.

Re: Fusible webbing or iron on interfacing

Posted: Sun 17 Aug 2014 8:27 am
by Lovelife
Apologies StrictlyTP, it is in Kyrenia.

If you walk down the main street from the car park, you will come to a small junction/crossroads, right turn goes down to the harbour, you need to turn left (there is a jeweller on the left hand side corner) walk a few yards past a shop selling suitcases outside, past a small café and the alley is on the left hand side of the road, walk up there and the shop is a good half way up, you will see it as there are wire baskets and other materials outside. The lady in the shop has it on a roll and you ask for the length you need. At the time she had two types a medium and a firmer type of interfacing.

That's a shame cjtill, mine was ok and stuck really well when used.

LL

Re: Fusible webbing or iron on interfacing

Posted: Sun 17 Aug 2014 9:02 am
by StrictlyTP
Thank you for the directions I will look for it