Kibkom North Cyprus Forum

I have purchased replacement brushes for a motor.

Due to the UK lockdown etc they have taken months to arrive.

I have discovered that they are the wrong size. Google is excellent and I managed to “shave” off the carbon bit and now it is the correct size.

I am now at a problem that is beyond my limited capabilities.

The spring and the brass bit at the end are the wrong size and I need to swap the correct bits from my old brushes to the new bit on the new brushes.

Any ideas would be greatly appreciated.

Photo to follow.

Thanks

cid:BF8C47284AA3B34D96AD94A4AEBCB2C6@sct-15-20-3174-20-msonline-outlook-8efcd.templateTenant

The nice man at Press Teknic (next to Freddies Bar as was) would be able to help you, I'm sure.

If he can't, chuck 'em over, and I'll have a decko...

That took me back to the 60s when I used to replace the brushes in the starter motor (or was it the generator) of my old Hillman Minx. Sorry if I'm off topic but I couldn't resist.