Kibkom North Cyprus Forum

Morning All. Does anybody know of a good gas fitter, if poss Corgi registered. My neighbour has an old gas fire, only used about a dozen times in the last 20 years. If poss he would like it serviced or at least inspected to see if it is still fit for purpose Failing that he would buy a new one but we cannot fine anybody that still fits gas fires into walls/old fire places etc. Have tried StoneArt and they only do electric. Thanks all. Tanky.

Unlike having Gas Safe in the UK which fitters must be registered with by law, there are are no such accreditation or certification schemes in the TRNC. Gates might be able to help or know someone that can. If not, try and get an experienced local tradesman, maybe even an ex-pat or someone that trained in the UK and may have been, or still is Gas Safe registered.

I found the following online if it helps;

Here’s what a qualified Gas Safe engineer typically assesses during a gas fire inspection:

1. Visual and Operational Checks
Signs of damage, corrosion, or wear on the appliance and pipework
Secure installation: appliance is properly mounted and stable
Correct positioning: safe distance from combustible materials

2. Ventilation and Flue Integrity
Adequate ventilation for combustion air
Flue condition and route: no blockages, leaks, or structural issues
Spillage test: ensures combustion gases are properly expelled

3. Gas Tightness and Pressure
Gas leak test: checks for leaks in pipework and appliance connections
Operating pressure: confirms the appliance receives correct gas flow
Burner condition and flame picture: flame should be stable and blue

4. Safety Devices and Controls
Thermocouple and flame failure device: shuts off gas if flame goes out
Ignition system: reliable and safe to operate
User controls: clearly marked and functioning correctly

5. Compliance and Documentation
Installation meets current standards under UK regulations
Manufacturer’s instructions followed

Record of inspection: findings documented, including any defects or recommendations

Thanks very much MnM much appreciated. I must admit I did think it would be easier than it is turning out to be. All companies I contact say only electric wall mounted fires. I shall persevere. As I said before he does have an existing gas fire installed but I would not think it is fit for purpose without having a full inspection.

You're welcome Tanky. If in doubt, don't use it, but if the appliance is ever used, I would recommend as a minimum, ensuring there is an element of through ventilation, (ie 2 windows open slightly at opposite ends of the room if possible, though even one window is better than none). And definitely, place a CO² Monitor on the opposite wall to the appliance and about 6 inches down from the ceiling, (taking any other structures into account such as beams / room divider arches etc - as always, check installation instructions). In fact for safety purposes, a CO² monitor is recommended to be used in any room with a fuel burning appliance). Remember Javier in Eldorado?

I had problems trying to get my gas boiler serviced, eventually got Mr Pipe to do it, I don't know if they deal with gas fires but you could ask them

Thanks very much for all your good advice.. Much appreciated

ARDIÇ - on the right hand side before the Bellapais traffic lights, heading towards the new harbour - have serviced my gas boiler every year since they installed it 20 years ago.

Don't know if they sell/service gas fires, but worth asking!