Candle Wicks
Moderators: PoshinDevon, Soner, Dragon
-
- Kibkommer
- Posts: 214
- Joined: Wed 10 Jun 2015 2:12 pm
Candle Wicks
Does anyone know if there is anywhere I can get candle wicks from? TIA
-
- Kibkommer
- Posts: 359
- Joined: Sat 02 Feb 2013 8:23 am
Re: Candle Wicks
This is not meant to be facetious but do you mean candlewick bedspreads or wicks for candles?
- Keithcaley
- Verified Member
- Posts: 8359
- Joined: Sat 21 Apr 2012 6:00 pm
Re: Candle Wicks
Fork Handles!
-
- Kibkommer
- Posts: 398
- Joined: Wed 11 Mar 2015 9:15 pm
Re: Candle Wicks
Not handles for forks, but wicks for candles.Keithcaley wrote:Fork Handles!
-
- Kibkommer
- Posts: 1585
- Joined: Mon 14 Jul 2014 10:19 pm
Re: Candle Wicks
Probably of little use (question being where to obtain "borax" and "braided cotton rope"), but....
"How to make a candle wick
Candle wicks can be made of borax.
Firstly, a solution of borax (15 ml) and salt (45 ml) in 250 ml water is needed. The water should be near its boiling temperature.
Secondly, dip a piece of braided cotton rope into the solution. Leaving the rope inside the solution and letting it absorb the borax for 24 hours will give the best results.
Take the rope out with tweezers and leave it to dehydrate for 1-2 days.
Technically, the candle wick is ready to use. Nevertheless, if needed to stiffen the wick, also apply the following steps.
Melt a candle of 60 ml with a small pot with approx. 2.5-5 cm height of water inside. Insert a metal box in the water, later add the candle to this box.
Dip the rope of borax into the molten candle. Cover the whole rope with candle as much as possible.
Leave the rope with candle to dry for a couple of minutes.
Repeat the previous two steps once or twice to obtain a harder wick.
The wick is ready to use after the candle covering process. "
"How to make a candle wick
Candle wicks can be made of borax.
Firstly, a solution of borax (15 ml) and salt (45 ml) in 250 ml water is needed. The water should be near its boiling temperature.
Secondly, dip a piece of braided cotton rope into the solution. Leaving the rope inside the solution and letting it absorb the borax for 24 hours will give the best results.
Take the rope out with tweezers and leave it to dehydrate for 1-2 days.
Technically, the candle wick is ready to use. Nevertheless, if needed to stiffen the wick, also apply the following steps.
Melt a candle of 60 ml with a small pot with approx. 2.5-5 cm height of water inside. Insert a metal box in the water, later add the candle to this box.
Dip the rope of borax into the molten candle. Cover the whole rope with candle as much as possible.
Leave the rope with candle to dry for a couple of minutes.
Repeat the previous two steps once or twice to obtain a harder wick.
The wick is ready to use after the candle covering process. "
-
- Kibkommer
- Posts: 5727
- Joined: Wed 25 Jul 2012 3:42 pm
Re: Candle Wicks
Have read jofra reply and it seams like an excerpt from Mrs Beaton with instructions to the under parlour maid.
- waddo
- Kibkommer
- Posts: 5092
- Joined: Sun 13 May 2012 7:21 am
Re: Candle Wicks
Warning! If you buy them from eBay - DO NOT BUY IN THE SUMMER - wait till the winter to get them sent by post or you end up with a single wick made up of many melted and then hardened wicks! Only good for lighting BBQ's if you do it wrong - trust me, I am the voice of experience. Good luck!
No matter how hard the past, you can always begin again.
-
- Kibkommer
- Posts: 214
- Joined: Wed 10 Jun 2015 2:12 pm
Re: Candle Wicks
Wicks for candles! Many thanks for all the replies