Aircon Service
Moderators: PoshinDevon, Soner, Dragon
-
- Kibkommer
- Posts: 120
- Joined: Fri 11 May 2012 12:54 pm
Aircon Service
Hi, Can anyone recommend a Air conditioner service person. We need a quote to service 3 aircon units in Patara Cityy.
-
- Kibkommer
- Posts: 383
- Joined: Wed 04 Apr 2012 2:15 pm
Re: Aircon Service
Would anyone know what E3 means on the aircon unit display. I know its a fault somewhere.
-
- Kibkommer
- Posts: 782
- Joined: Thu 10 May 2012 1:51 pm
Re: Aircon Service
Call Vaughan 05338458494. He sent an engineer to do mine this week, and they will check to see if you need gas as well.
-
- Kibkommer
- Posts: 120
- Joined: Fri 11 May 2012 12:54 pm
Re: Aircon Service
Many thanks for reply, have talked to Vaughan.
-
- Kibkommer
- Posts: 383
- Joined: Wed 04 Apr 2012 2:15 pm
Re: Aircon Service
I would like my aircon repaired, but as I only have the one that needs doing, it seems rather expensive to pay 100tl for the call out charge and then any maintenance as an extra, or do I have this incorrect.
-
- Kibkommer
- Posts: 56
- Joined: Thu 05 Apr 2012 2:55 pm
Re: Aircon Service
Solic
Found this on the website for our AC . Error Code E3:
--------------------------------------------------------------------------------
A. Outdoor Sensor: (Heat Pump Only) this code means that the PC board is not receiving a signal from the copper sensing bulb mounted to the copper tubing near the condenser coil.
Diagnosis: visually inspect and/or use an ohmmeter to check the following:
Sensor has come unplugged from the PC board. OR.
Sensor has failed and must be replaced. OR.
Sensor wire has shorted or opened necessitating the repair of the wire, since this wire runs through one or more walls, the likelihood of the wire being cut is probable.
Mavis x
Found this on the website for our AC . Error Code E3:
--------------------------------------------------------------------------------
A. Outdoor Sensor: (Heat Pump Only) this code means that the PC board is not receiving a signal from the copper sensing bulb mounted to the copper tubing near the condenser coil.
Diagnosis: visually inspect and/or use an ohmmeter to check the following:
Sensor has come unplugged from the PC board. OR.
Sensor has failed and must be replaced. OR.
Sensor wire has shorted or opened necessitating the repair of the wire, since this wire runs through one or more walls, the likelihood of the wire being cut is probable.
Mavis x